Elecrow 5" ESP32S3 connecting with XBee module and GPIO_D

BlairKentBlairKent
in Elecrow HMI Display

I am almost finished my project but can't get my Xbee module to TX/RX on GPIO_D connection. Not sure how to define the software pins. Thanks

Comments

  • JennieJennie

    Hi BlairKent,
    To further handle the issue, could you help provide the following :
    1. Please tell us exactly which of our products you are using. We need to know the SKU No. . Or please provide the purchase link for the product. so that we can continue to analyze the issue

    1. Also, please provide the order number, product purchase link(if applicable), along with the name of the retailer, store, platform, or website where you purchased the product.
      This allows us to work with the seller to provide you with better service.

    Best regards,

  • BlairKentBlairKent

    Jennie
    This is the product from Amazon.ca
    www.amazon.ca/dp/B0DL5WB7RQ?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
    ESP32 Display-5 inch
    SKU DIS07050H V3.0
    As best I can see this model does not have an external UART output for transmit and receive unless I am misreading the schematics
    Thanks,
    Blair Kent

  • JennieJennie

    HI BlairKent,
    I am sorry, this issue requires some time for our team to analyze/investigate. I will get back to you as soon as we finish the analysis. Please wait patiently.

    Sorry for the inconvenience caused.
    Warm regards,

  • JennieJennie

    HI BlairKent,
    This device only has one UART, uart0, that can be used.

    Warm regards,

Sign In or Register to comment.

© Elecrow Stone 2026