Elecrow 5 inch esp32s3 upload issue
So, this is mostly informative for people like me you were too lazy to scroll all the way down the page and spent hours trying to figure out why I was unable to upload my code to the esp32s3 chip on the crowpanel 5 inch display.
Because if you scroll about 3/4 of the way down the settings you need to upload to the esp32s3 are there under section 3, board settings. Once I change the settings in the arduino ide, it uploaded fine. You would think they would put it at the top of the page where it really needs to be, but no that would be too easy. Anyway, hopefully this helps someone.
Comments
Dear ZK_66,
Thank you for sharing and your feedback.
We will forward your feedback to the relevant departments for analysis and improvement.
Thank you.
Best regards,