Servo jitter on CrowPi2

The lesson on using an SG90 servo works but the servo jitters in both positions.
Changing to 2 seconds in each position and +/- 10 degrees still jitters. Is this a power supply overload problem?
If the pulse width is stable then the servo should stay quietly in the selected position.

Comments

  • Hi, Rovman,
    Our technical support team is currently looking into the issue in your post. Please be patient, and we will get back to you as soon as possible.
    Best regards,

  • Hi, Rovman,
    Did you use raspberry Pi 4 inside CrowPi2? or raspberry Pi 5? Please tell us this so that we can further check this issue.
    Thanks! Have a good day!

Sign In or Register to comment.