Uninstall X
Pi 4 (Bullseye) running Octoprint. Had a Elecrow 7 for Octodash, and went to switch it for an Elecrow 5 resistive.
Bad move.
Initially I edited config.txt, and the screen ran - but no touch interface. Then I ran LCD5-show, which installs X. I'm running headless, so I don't want/need X, and the installation was faulty - X fails on startup, and Octoprint will not run. I've tried several ways of uninstalling based on web searches, but none resolve the failures.
Is there a way to undo this, or am I going to have to fully reinstall Octoprint?
Thanks -
Comments
Dear @kbqHV ,
Could you confirm what SKU of Elecrow 5 resistive you want to use?