Jully
Jully
About
- Username
- Jully
- Joined
- Visits
- 1,171
- Last Active
- Roles
- Moderator, user_manager
Comments
-
Dear surdilamak, We sincerely apologize for the inconvenience. We need some time to analyze your video and will get back to you as soon as possible. Please wait patiently.
-
Dear Blair, That's great! Good job! The issue may be caused during transportation. We will transfer your feedback to relavant departments for analysis and future improvement. Thank you for the update! Warm regards,
-
Dear pkirkham, May I ask which version of the operating system you are using? We developed this based on the Raspberry Pi Buster system. Warm regards,
-
Dear Carl, We apologize for the inconvenience. To further troubleshoot the issue, could you please follow these steps: * Power off the device (allow the battery to fully drain), then power it back on. * Connect the device to your computer via a …
-
Dear Blair, The hardware differences between versions V1.3 and V1.4 are minimal, allowing them to run the same program. so this may be a hardware problem. please check if the touch ribbon cable on the back of the device is properly connected and i…
-
Dear pkirkham, We sincerely apologize for the inconvenience. We need some time to analyze your video and will get back to you as soon as possible. Please wait patiently. We sincerely apologize again for the inconvenience.
-
Hi gino_elecrow, Sorry for the inconvenience. pls refer to the links: https://github.com/Elecrow-RD/CrowPanel-1.28inch-HMI-ESP32-Rotary-Display-240-240-IPS-Round-Touch-Knob-Screen https://www.elecrow.com/wiki/CrowPanel_1.28inch-HMI_ESP32_Rotary_Dis…
-
Hi, andrewhuster, The accompanying image has prepared this: [Photo](Image) Thanks! Warm regards,
-
(Quote) HI michaelhaws, The issue was ultimately traced to a problem with the cable; replacing the cable resolved it. Warm regards,
-
Hi, informationdata, Sorry , it cannot programmed using a phone