nicholasperratt
nicholasperratt
About
- Username
- nicholasperratt
- Joined
- Visits
- 212
- Last Active
- Roles
- Member
Comments
-
Also can I get an explination on why the I2C and power switch are clashing
-
I have been trying to get this power switch to function properly, but regardless of if I use the boot folder or the rc.local for the power button start up, my I2c devices (lcd, matrix and light sensor) all end up with a timeout error. Is there a w…
-
have been trying to figure out how to use the uids The RFID TAG has a uid of 119,212,75,161,73,8,4,0,2,135,184,120,187,99,42,29 And the RFID CARD has a uid of 227,236,201,66,13,84,0,98,99,100,101,102,103,104,105 How can I then call that in a sc…
-
I mean I have a fair idea on how to program it, I'm really just needing how I would go about detecting different cards to call
-
After trying a few scripts and them not working I've now got a script that works and I can now safely shutdown my raspberry pi with the push of a button. It uses pin 26 which controls the servo and the independent up button so I can clear the use of…
-
Daaaaang, thank you Tony! I'll be working on that then as my project! Thank you again you've been a massive help
-
I'd also like to know if you could use either the button matrix or the 4 individual buttons to act as a power button?
-
I was meaning like is it pin 26 and gnd that I need or the pin 26 and 5v or the 5v and gnd?
-
Thank you, are there any specific servo pins that will work? I'm assuming I'll need to code my own power script using sudo halt or sudo shutdown
-
https://forum.elecrow.com/discussion/comment/53#Comment_53 Thanks, but with the Crowpi I received I didn't get a power adapter with a switch, I will see if I can get one online. In regards to the raspberry pi how would I add the power button to th…