lokee
lokee
About
- Username
- lokee
- Joined
- Visits
- 17
- Last Active
- Roles
- Member
Comments
-
I'm happy to report that I can now power the display panel with the same LiPo 3.7V battery! After I opened up the back of the panel, I did see + and - marked on the board for each pin of the battery socket. So I connected the corresponding wires fro…
-
@Jennie, should I measure the volage difference between VCC and GND pins you circled with or without my LiPo battery connected to the bat connector on the board? I'll do the measurement this weekend when I'm back home from a trip. Thanks!
-
@tinusium May I ask which battery you used with the panel and is your panel the 7" e-paper or LCD? I'm having trouble powering 5" e-paper with 3.7v Li-Po battery (3000mah) from Amazon. From what @Jennie mentioned in my separate thread, the…
-
Thanks for the quick response. I have ordered the 3.7 LiPo (Li-ion was a typo) battery following the Amazon link in my first post and connected the battery's jst1.25 plug to the 1.0 plug on the e-paper panel through some jumper cable, and jst1.25 fe…