Comments

• This really sounds like a MakeCode + Bluetooth pin conflict. When Bluetooth is active, certain pins get reserved for system functions, so the H-bridge never receives the reverse signal for your second motor — which is why it only runs forward unless…

  in Second motor not working in one direction with Bluetooth projects using crowbit inventor kit Comment by hazelijamas 12:41PM
• Sounds like a pin/logic conflict, not a bad motor. Since both motors work fine in LetsCode, the issue is likely how MakeCode + Bluetooth are mapping pins or handling direction signals. Some pins get reserved or repurposed when Bluetooth is enabled, …

  in Second motor not working in one direction with Bluetooth projects using crowbit inventor kit Comment by hazelijamas 12:39PM
• Nice breakdown — Raspberry Pi 5 really is a beast for budget media setups. It’s crazy how much power you get for the price. Perfect for streaming, music, and even retro gaming if you want to push it further. Great guide for anyone wanting a simple, …

  in Share Knowledge 👍Building a Low-Cost Media Center with Raspberry Pi 5 Step-by-Step Comment by hazelijamas 12:38PM
• From that config table, it looks like TF card and speaker output aren’t active together in the same mode. TF card modes pair with MIC, not SPK, so you can read music from the card but not output it over I2S/amp at the same time by default. You may n…

  in [CrowPanel Advance 7.0-HMI ESP32] Audio output & TF card usage. Comment by hazelijamas 12:38PM