danilo
danilo
About
- Username
- danilo
- Joined
- Visits
- 35
- Last Active
- Roles
- Member
Comments
-
(Quote) Hello @Jennie , Is my Pi terminal preconfigured for 4G and lora? What can I do now? I need the two RS485 Ports on my Pi terminal, but 4G or lora are not mandatory. What is to do for going back without 4G and/or lora? Just change the configur…
-
(Quote) /dev/ttyAMA2 do not work. I think, in need first the information, witch GPIO-No from CM-4 board is connected with which RS485 driver. And the other problem is, I send any 0 and 1 to GPIO-8, then I can see on A1,B1 AND on A2,B2 from RS485 the…
-
(Quote) Hello @arnemann44, I have the same problems. No RS485 work. I have try all names tty1, ttyAMA0, ttyAMA1, ttyAMA2 and ttyS0, but the RS485 do not work. I want to know which pins from the PI terminal connector with RS485 driver on the board a…
-
(Quote) Yes. With WiFi and 4G-Modul. But both modules are in the moment not installed on the board.
-
Yes. With WiFi and 4G-Modul. But both modules are in the moment not installed on the board.