Comments

• Hi I put the crowtail PIR on UART0. I declare Pin 44 as Input, but I can't detect movement.

  in CrowPanel 7" / Crowtail LED + Crowtail PIR Comment by Yannick January 4
• Hi Jennie Is the serial port this ? (Image) If yes, the number GPIO is 38 like the GPIO_D pin

  in CrowPanel 7" / Crowtail LED + Crowtail PIR Comment by Yannick December 2024
• But my LED don't light on. I have 4 wires (Black, red, White and Yellow wire) link on GPIO_D output. Yellow wire goes to my resistor, and the black wire to Ground. Is it Ok ?

  in CrownPanel - MQTT Comment by Yannick November 2024