
Pearl
Pearl
About
- Username
- Pearl
- Joined
- Visits
- 691
- Last Active
- Roles
- Member
Comments
-
Please contact Elecrow Tech Support at techsupport3@elecrow.com
-
A Power Bank (Battery) was originally included with the CrowPi2 Advanced and Deluxe Kits to be installed inside the Storage Tray but has since been discontinued as it is no longer listed in the kits comparision table on the current product page. And…
-
Please refer to this post
-
No, there is no method to connect a 2nd HDMI Display through the Raspberry Pi 5 Bridge Board, because the Micro-HDMI connector (J102) is just a dummy connector and does not pass any signals from the HDMI1 port of the connected Raspberry Pi to anywhe…
-
@profed Looking for the latest CrowPi-L OS (Bookworm) image, please refer to this post.
-
Glad to hear that you have everything sorted!! Perhaps those cables are for charging only, which has just the V+ (VBUS) and V- (GND) pins connected and not the D+ and D- pins that carry the data signal. Because not all USB cables are created equal…
-
Also for just in case, can you upload the /boot/firmware/config.txt from your RPi-3. If you put the microSD card in a Windows PC, it would the \firmware\config.txt file. I would like to review the config settings to see if there is anything unusual…
-
That is not the issue. The Driver board get power input from the DC 12V/2A Power Adapter. The Driver board send digital signal out from its Micro-B ( for Touch) to the USB-A port of the Host (i.e. RPi, PC). The Touch Monitor Kit includes 2 USB cabl…
-
So, if the OS unable to detect the Touch interface when the USB cable for the Touch interface is plugged in. Then, there is a problem either, 1. The USB-A to Micro-B cable is defective. Try replace the USB cable for the Touch interface with a know…
-
Couple of questions to confirm the screen messages, 1) Was those messages starting from timestamp [ 52.321982] to [ 52.812723] appear when you plug in the USB cable? The deviceID shown correspond to your mouse. 2) Messages starting from timestamp …