Comments

• Thank you, for some reason, the only ones I found were fuzzy.

  in 7"CrowPanel Schematic Comment by MicroGuy May 7
• So far, I'm having difficulty also. What used to work on the older board, no longer works. I'm not sure what all has changed. I'll keep looking, I have much to sort through. But as of now, even the backlight doesn't work. The most basic serial …

  in What is the difference between CrowPanel Advance 7.0-HMI ESP32 AI Display v1.0 and v1.2 Comment by MicroGuy May 2
• Is it not working? It looks pretty good to me, maybe more than you need. I haven't checked, but my *.ini file looks very similar, and works fine. I did change it so most of the libraries point to one location, instead of installing the libraries ev…

  in Looking for Platformio.ini settings for ELECROW ESP32s3 7" HMI Comment by MicroGuy January 23
• Never mind, I got it. There's still a couple of issues with the touch screen. I get several errors after "wire.h" is started up, [ 821][E][Wire.cpp:159] begin(): Bus already started in Master Mode. [ 821][E][esp32-hal-gpio.c:95] __pi…

  in LVGL Ver.9 setup, specifically buffers.... Comment by MicroGuy January 16