Jennie
Jennie
About
- Username
- Jennie
- Joined
- Visits
- 996
- Last Active
- Roles
- Moderator
Comments
-
Regarding the issue of not being able to power on normally, please first check if the cable shown in the image below is installed correctly and whether the latch on the corresponding slot is properly engaged. [Photo](Image) (Image can be enlarged…
-
(Quote) Dear Sevener Please open the case containing the Raspberry Pi on the back of the device, and then check if the wiring between the Raspberry Pi and other components is stable. Thanks! Best regards,
-
(Quote) Dear Customer, Thank you for reaching out to us and for your continued support. We have received your email, and our technical support team is reviewing the details. Please allow us some time to look into the matter. We will get back to yo…
-
Dear Inbux, We are very sorry for the inconvenience caused to you. The schematic diagram is now available in the GitHub link: https://github.com/Elecrow-RD/CrowPanel-Advanced-7inch-ESP32-P4-HMI-AI-Display-1024x600-IPS-Touch-Screen/tree/master/Eagle…
-
Dear Horsepants, During WiFi OTA (Over-The-Air) updates, WiFi may: consume significant CPU resources, consume PSRAM bandwidth, enter a prolonged critical section, disable some interrupts (including those required for I80/RGB refresh), block LVGL's d…
-
Dear feydaykyn , You can also use MakeCode, just like using the micro:bit. https://makecode.microbit.org/#editor Thanks ! Warm regards,
-
(Quote) Dear Luka, The firmware of this device was developed by the meshtastic team in collaboration with us. Generally, if the meshtastic website indicates it as a stable version, it means it is stable. Please use the latest stable version. (Image…
-
Dear Customer , Please provide the code and photos of the device wiring for us to analyze . Thanks! Warm regads,
-
(Quote) Dear Roycejp Sorry for the late reply . Please reinstall the entire Arduino environment. There might be some issue with the environment configuration that is causing the problem. Thanks！ Warm regards,
-
(Quote) Dear Marvin , Thank you for the support to us . Sorry, we don't have a repair method applicable to MeshCore. We suggest you contact the developers of MeshCore for assistance. However, we recommend that you first try our solution on Meshtast…