Jennie
Jennie
About
- Username
- Jennie
- Joined
- Visits
- 826
- Last Active
- Roles
- Moderator
Comments
-
Hi Bernhard, Thank you for the patience while we were looking into the issue. Please try to set the i2c pins. We see that there is no i2c pins set in your code. Please refer to the following code: include "Wire.h" include "PCF8575.h…
-
(Quote) Hi Bernhard, Our technical support team is currently looking into your issue in your email. Please be patient, and we will get back to you as soon as possible. Best regards,
-
Dear penatar, Thank you for your understanding and patience. Today we tested and indeed there is no data on pin 38, but pin 20 is normal. Even with a pull-up resistor on pin 38, it still doesn't work. But we checked and the hardware is normal. We …
-
(Quote) Dear sylvanoMTL, Hope you are doing well! What is the hardware version of your product? (You can check the version number on the back of the product.) Different hardware versions have corresponding schematics. (Image)
-
(Quote) Dear penatar, We are very sorry for not replying to you so late. We will expedite your question and try to reply you as soon as possible within two days. Thank you for your understanding and patience. We are very sorry for the inconvenience …
-
Hi, Harshit, 1 Close to the bottom of the page, there is an image showing the brightness. (Image) (from : https://www.elecrow.com/esp32-display-7-inch-hmi-display-rgb-tft-lcd-touch-screen-support-lvgl.html) 2 I am sorry that currently we do no…
-
(Quote) Dear cranberry, We have already sent you an email regaring this issue. Please check your email. Thanks!
-
Dear sylvanoMTL, Hope you are doing well. Are you using this product (https://www.elecrow.com/esp32-display-3-5-inch-hmi-display-spi-tft-lcd-touch-screen.html)? This product only leads out the pins with interfaces, no extra leads To use spi, pleas…
-
Dear sylvanoMTL, I hope this message finds you well. Thank you for reaching out. Sorry for the inconvinience caused. Our technical support team is currently looking into the issue in your message. Please be patient, and we will get back to you as s…
-
Dear minhduc, The I2C port can only use the I2C module, not the CAN module. Because the corresponding pins have been used by the touch screen, they can only be used as I2C. Thanks! Have a nice day!