Jennie
Jennie
About
- Username
- Jennie
- Joined
- Visits
- 996
- Last Active
- Roles
- Moderator
Comments
-
(Quote) Dear Sevener, How did you connect the monitor? Could you provide some photos or videos? Normally, just connecting it with an HDMI cable is sufficient and no settings are required. Thanks! Best regards,
-
(Quote) Dear Marvin , May I ask if you have tried the method we provided in the last comment ? How was it? Did it work? Thanks! Best regards,
-
Dear roycejp， Sorry for the late reply. May I ask if you are using the library files we provided? If not, please try these instead: : https://www.elecrow.com/download/product/CrowPanel/ESP32-HMI/7.0-DIS08070H/Arduino_Tutorial/libraries.zip also，…
-
(Quote) Dear NetMassimo , Hope you are doing well. The keyboard and mouse are connected to the Raspberry Pi, not to our screen. The keyboard and mouse are connected to this position. [Photo](Image) Thanks! Warm regards,
-
(Quote) Dear Scottie606 Please shoot a video and send it to us so that we can see how you operated and the specific fault phenomenon. If the video is too large, pls upload it to a platform(like Google Drive), then send the link to us. Warm regard…
-
(Quote) In addition , Did you read/receive this email? Look forward for your reply . Thanks, Best regards,
-
Dear Mshettha , Hope you are doing well. Sorry for the late reply . For the brightness issue, pls try the attached file . Thanks , Best regards,
-
Dear Customer/Sender, Thank you for reaching out to us and for your continued support. We have received your messages, and our technical support team is reviewing the details. Please allow us some time to look into the matter. We will get back to …
-
(Quote) Dear Customer, Thank you for reaching out to us and for your continued support. We have received your messages, and our technical support team is reviewing the details. Please allow us some time to look into the matter. We will get back to…
-
(Quote) Dear Marvin, We sincerely apologize for the poor product experience. Please view the following: * Regarding the issue of improving accuracy: Are you encountering this problem while using the Meshtastic firmware? If so, please try this me…