Jennie
Jennie
About
- Username
- Jennie
- Joined
- Visits
- 999
- Last Active
- Roles
- Moderator
Comments
-
Dear @GarryT, Thank you for bringing this to our attention. I’ve tested the PCB files on my end, and they open correctly in Eagle. However, it seems there might be an issue on your side. Could you please try downloading the files again and ensure yo…
-
Dear @Nutmeg , The CrowPanel 7'' display only has the 38-pin available, and there are no surplus pins for additional connections.
-
Hi Yannick, This is a I2C port on the photo.So It's can't be used as a normal input/output . This is a serial port as below shown (Image)
-
I'm glad you were able to identify and resolve the issue on your own. This is exactly what I wanted to point out – the need to use a standard USB-C cable that supports** USB 3.1 data transfer and DisplayPort.** I hope our products provide you with …
-
Dear @GarryT , Thank you for your feedback. We apologize that currently do not have such 3D files. Our engineers are working hard on creating them, and they will be updated on the website once available. Please stay tuned.
-
Dear, Are you using our example code or your own code？
-
Hello @fableman , Can be connected to 5V at the same time, connecting the battery can also charge the battery
-
Hello, You don't need to uninstall the driver, the RS485 will work when you turn on.
-
Hello @Yannick If you don't use the serial port, you can connect it to the serial port.
-
(Quote) Hi , Please press "F1" first to check if the signal source selection is correct