Jennie
Jennie
About
- Username
- Jennie
- Joined
- Visits
- 827
- Last Active
- Roles
- Moderator
Comments
-
Thank you for your suggestion. We will record it and consider whether to carry out product research and development. Please stay tuned for product updates on our website: www.elecrow.com. Additionally, Customized requests can be discussed(based on M…
-
Hi bairloch. If you want to make sure that the touchpad is in an available state. You can change the touchpad status by F2 or Fn+F2. when tapping F2 doesnot work, you can try to tap Fn+F2. To rule out keyboard and touchpad issues, remove Bridge …
-
The development work of Pi Terminal-7” HMI Panel compatible with CM5 has been completed, but it is now in the testing stage. Please stay tuned for updates on our website: www.elecrow.com.
-
Dear @lokee , Please use a multimeter to measure whether there is 3.3v.If not ,it's probably a bad circuit board. (Image) You can contact our techsupport@elecrow.com email for follow-up support.
-
Hello, The Advance ESP32 HMI speaker resistance is 8Ω.
-
Hello ， The error message indicates that font 40 is being used—this is a font you defined, right? You need to enable this font setting in the lvgl_conf.h file. Additionally, did the elecrow code successfully compile?
-
I'm sorry for not responding to your message in a timely manner. If you need a quick reply, please send an email to techsupport3@elecrow.com Here is the answer to your question: The resolution aliasing and alignment issues may be the root cause of t…
-
Hello, Check out the test results at the end of the video https://youtube.com/watch?v=vzq8-aMmTOQ&t=11s
-
Hello @SM0PYH , To assist you better, please provide the following information :) : 1.Is this the product you are using? (Image) 2.Which TX pin are you using? Is it functioning correctly? The RX pin is set to pin 38, but there is no Serial1.begin(…
-
(Quote) Please download via this link: https://drive.google.com/drive/folders/1npWkVzctd7e0Y6H5hahk8uxGhy9idxCz