Jennie
Jennie
About
- Username
- Jennie
- Joined
- Visits
- 827
- Last Active
- Roles
- Moderator
Comments
-
Hi, Guille818, Our technical support team is currently looking into your issue in your post. Please be patient, and we will get back to you as soon as possible. If you have any additional questions, feel free to ask us. Best regards,
-
Hi, pbhogan, We’re sorry, but at the moment there are no development plans for an e-paper display of that size. Please stay tuned to our official website for updates: www.elecrow.com.
-
(Quote) Hi, rhaugen, Thank you for your patience in troubleshooting the issue. I am sorry for the inconvinience caused. Our technical support team is currently looking into your issue in your email. Please be patient, and we will get back to you as…
-
(Quote) Hi deathcat99, Yes, you just need to connect a 7.4V battery to the laptop.
-
Hi, Bernhard Thank you very much for sharing this information!
-
Hi albova， Please change the diagram according to the image below. (Image)
-
Hi mshettha, The Pi Terminal 7" can normally connect and work with RS485 sensors without any special limitations. Could you please describe in more detail how you are using it? What is the exact model of the sensor you are using? It would be he…
-
Hi Oliver, The SPI interface is shared by both the wireless module and the SD card. Please refer to the schematic below. (Image) Have a good day!
-
Hi albova， Normally, if connected directly, there will be this low-level voltage issue at 1.4V, which may cause data distortion. You can try adding a pull-up resistor on the B port of the TXS0108E (the side connected to the Arduino Mega2560’s 5V).…
-
Hi Nikkk, Under the Linux environment, normally both Arduino IDE and SquareLine can work properly, as they both have Linux versions. However, some libraries may be tailored for the Windows environment and might not work correctly on Linux — in such …