Comments

• @Bwanna Hello there, The 2.4-inch display uses ILI9341_DRIVER. Here's the setup file for the 2.4-inch ESP32 display: https://forum.elecrow.com/uploads/172/Z1EBISIFEK3Y.zip

  in Wizee ESP32 2.4" HMI TFT not displaying Comment by Elecrow August 2023
• @rickbase1 Thanks for your feedback, we will improve the wiki tutorial steps. Now you can download the lesson code in the external link section of the product page, there is a "necessary library" folder inside, please install these librar…

  in 📢#NewArrival ⭐Elecrow ESP32-S3 3.5" TFT ESP Terminal RGB Touch Display Comment by Elecrow June 2023
• @ajax12 Hello there, Have you installed the firmware for the PI Pico? If not, you can refer to the instructions in the following link for installation: https://www.elecrow.com/download/product/RPK13250K/Raspberry_Pi_Pico_Advanced_Kit_tutorial_V1.0.p…

  in Problem getting python to work Comment by Elecrow June 2023
• Dear @mokjpn , Thank you for sharing this issue and solution. This is very useful feedback, and we will make sure to communicate it to the technical team so that they can investigate and fix it. If you encounter any other issues or have any other fe…

  in GrowCube setup failure on 192.168.1.0/24 subnet LAN Comment by Elecrow May 2023
• @SpareSimian Hello there! I'm sorry that CrowPi2 is not an open-source project, so I can't provide you with a complete schematic. This is the wiring diagram of the 7-segment display module, I hope it can help you. https://forum.elecrow.com/uploads/9…

  in Incorrect wiring of CrowPi2 7-segment display Comment by Elecrow May 2023
• Yes, this is the order number we need. Please send your order number and questions along with your needs to order@elecrow.com. There will be staff to handle your problems. Best regards, Elecrow Team

  in CrowPi-L documentation? Comment by Elecrow March 2023
• @treo The reason for this problem may be that the acquired IP address is already occupied by other devices. You can try the following steps: 1. Move the mouse to the wifi icon in the upper right corner of the screen to view the IP address of CrowPi2…

  in crowpi2 wifi issue Comment by Elecrow March 2023
• @GeorgeY Hi George, please try hdmi_timings=1024 1 50 18 50 600 1 15 3 15 0 0 0 60 0 40000000 3

  in RC101S 10.1 Comment by Elecrow March 2023
• @jaedon Hi, May I ask if only "end" is displayed after opening the course? If yes, then you need to re-download and re-flash the CrowPi2 image, the download address of the image is: https://drive.google.com/drive/folders/1ViXk3Yhch0d6HS5Pj…

  in Minecraft Course Selections Blank Comment by Elecrow March 2023
• @jaedon Hi Jaedon, thanks for your feedback and advice. We'll add some more tags for your convenience.

  in How to start a great discussion Comment by Elecrow March 2023
More Comments