Comments

• Hello @GaLeX , 1.Can the entire content be displayed when the page zoom ratio is 100%? What if the page zoom ratio is less than 100%? 2. What is the order number for placing orders on smartphone?

  in Web site problems Comment by Elecrow October 2023
• Hello @dlv Sorry for the inconvenience caused to you by the wrong document content. You can check this link:https://forum.elecrow.com/discussion/495/how-to-upload-the-esp32-display-factory-program-by-arduino-ide to learn how to compile and run the …

  in ESP32 Touchscreen Monitor 2.8 Inch TFT compile issues in Arduino IDE Comment by Elecrow October 2023
• @Andy245 Hello Andy, The reason why the screen turns on and off may be poor USB contact. Please replug and unplug the connection in the picture below: 1. 4pin USB cable 2. 50mm flat cable https://forum.elecrow.com/uploads/060/UKU3H07PKOZ9.png

  in my screen keeps turning on and off Comment by Elecrow October 2023
• the ESP32 Display cannot connect the CANBUS and I2S DA modules

  in Want to connect CANBUS and I2S DA modules to the ESP32 Terminal Comment by Elecrow September 2023
• CrowBot's motor is driven by an L9110.  https://forum.elecrow.com/uploads/013/VK1OANE1Z01M.png According to the datasheet of L9110, when IA is high and IB is low, the motor rotates forward. Conversely, when IA is low and IB is high, the motor rotate…

  in Explanation of CrowBot movement codes Comment by Elecrow September 2023
• Hello, is the button on?

  in The connection LED on CrowBot is not lit when connected to the computer. Comment by Elecrow September 2023
• Hi @Jason Please try the following steps: Click the search box in the lower-left corner of your computer screen and search for Control Panel https://forum.elecrow.com/uploads/618/ZV1WA8XSB196.png Enter the control panel and find Tablet PC Settings …

  in Burnin Mode on 8-Inch Portable Monitor Comment by Elecrow September 2023
• the password is 1

  in CrowPi2's login screen is not displayed Comment by Elecrow September 2023
• Hello @Jason , Do you mean when you touch the SH080T, the cursor on the primary monitor will move too? You can try to set the multiple monitor mode to Extend mode Does turning off the power button help?

  in Burnin Mode on 8-Inch Portable Monitor Comment by Elecrow September 2023
• https://forum.elecrow.com/discussion/527/esphome-on-esp32-display-5-lcd Hello Steph, I'm sorry that our software engineer is also facing this problem. And it hasn't been resolved yet. Once we have any progress, I will get back to you ASAP. Best rega…

  in ESPHOME on ESP32 display 5" LCD Comment by Elecrow September 2023
More Comments