Elecrow
Elecrow
About
- Username
- Elecrow
- Joined
- Visits
- 1,337
- Last Active
- Roles
- Member
Comments
-
Hello @samnorris , If I2S is not initialized, it is disabled. If you use the i2s pin, you need to connect it from the ESP32 chip instead of using the 4pin connector, because there is also an NS4168 chip between the ESP32 and 4pin connectors. And yo…
-
Hello @lboue ， The schematic of version 2.1 is the same as version 2.0, they only have different PCB structures
-
Thank you for your feedback. Because we set the backlight in the main program, we comment out the backlight definition in the library.
-
(Quote) Hello, May I kindly ask do you mean software similar to nextion-editor? If yes, we are sorry that we have not developed the corresponding software. If you mean the program code, please enter the wiki(Each product page has a corresponding pro…
-
You can use CR1220 CR: Lithium battery 12: Diameter 12mm 20: Thickness 2.0mm
-
@redbullmarky Maybe this 5-inch capacitive touch-screen will meet your needs: https://www.elecrow.com/rc050s-hdmi-5-inch-800x480-capacitive-touch-monitor-built-in-speaker-with-backlight-control.html (Image)
-
We're sorry the HDMI cannot be driven via GPIO. Currently, the only 10.1-inch screen we sell can meet your needs.
-
Yes, please get in touch with order@elecrow.com for a replacement module.
-
The TFT_eSPI library does not support our 7-inch board yet, so we need to rewrite the code, but the good news is that most of the function names and usage methods of the TFT_eSPI library and the lovyanGFX library are the same, so there is no need to…
-
They cannot be used at the same time, because there is only one IIC port, so asynchronous communication is required to enable touch and sensor. During communication, make sure it does not take up too long, otherwise it will affect the touch function…