Comments

• https://forum.elecrow.com/discussion/498/growcube-networking-mode Hello Bonuz，are you in direct mode? Can you tell me more about how you operate? Pictures or demo videos would be great.

  in Growcube networking mode Comment by Elecrow August 2023
• https://forum.elecrow.com/discussion/496/home-assistant-and-growcube Hello there.To begin, you need to download the latest app (currently version 4.0) from the Google Play Store. Afterward, you can upgrade the hardware firmware by adding the device …

  in Home Assistant and GrowCube Comment by Elecrow August 2023
• Hello @Old_nerd Please try to follow: https://forum.elecrow.com/discussion/495/how-to-upload-the-esp32-display-factory-program-by-arduino-ide Or you can upload the "Hello World" sketch instead. https://forum.elecrow.com/uploads/316/I1KRX…

  in Wizee-ESP32-s3 wz8048c050 5" HMI TFT problems. Comment by Elecrow August 2023
• Hi Tim, The type of the battery connector is PH2.0 Best regards, Elecrow TS

  in ESP32S3 5 Inch Display - Battery voltage Comment by Elecrow August 2023
• Hello @jjtimo 5 volts would be good.

  in ESP32S3 5 Inch Display - Battery voltage Comment by Elecrow August 2023
• https://forum.elecrow.com/discussion/476/where-can-i-find-dev-sda Hello, You can find the SD card in the location indicated by the image. Please refer to the image. https://forum.elecrow.com/uploads/740/Q02S4FRZ1F8V.png

  in Where can I find /dev/sda? Comment by Elecrow August 2023
• https://forum.elecrow.com/discussion/472/schematic-for-vs1053-mp3-shield Hello, you can through the website https://www.elecrow.com/download/vs1053.pdf to view pin function and the principle diagram.

  in Schematic for VS1053 MP3 Shield Comment by Elecrow August 2023
• @Tahira Hello there, I am sincerely sorry for the inconvenience. The cause of the problem may be an error in burning the image, please burn the image again to see if the problem can be solved. Here's the download link for the CrowPi2 image.

  in No Lesson Found Comment by Elecrow August 2023
• @Timo Hello, May I ask what version of the esp32 package you installed? Is it 2.0.3? Before you download the program to the terminal, you need to press and hold the boot button, and then press the reset button to make the terminal enter the burning…

  in ESP Terminal with 3.5inch SPI Capacitive Touch Display and Camera Comment by Elecrow August 2023
• @bbrook Hello there, The driver library for 4.3-5.0-7.0-inch screens is not TFT_eSPI, but Arduino_GFX. Because these three screens are not SPI screens, but RGB screens. Here are the links to the libraries for the three screens: 4.3-inch: https://dri…

  in ESP Display 5 Inch Settings Comment by Elecrow August 2023
More Comments