Elecrow
Elecrow
About
- Username
- Elecrow
- Joined
- Visits
- 1,337
- Last Active
- Roles
- Member
Comments
-
Hello @davet999 , Passwords with only numbers do not work. You can add any letters to your password
-
Hello @padi , Maybe you can refer to https://youtu.be/rOuW5nuyFyk https://github.com/qq71680264/ESP32_Display_LVGL_MP3_Player
-
Hello @Shailen , Please run sudo i2cdetect -y 1 in the terminal to see if it can detect the chip, the address should be 03
-
Hello @iotdevzone , Please send your order number to order@elecrow.com, and the stuff will help you search the detail information.
-
Hello @hymd ， This Excel sheet was made many years ago, so a lot of the information is out of date. May I kindly ask are you planning to use PCBA services at elecrow? After you upload your PCB files and BOM to the PCBA quotation page, a project man…
-
Hello Mark, IO36 and IO377 have been occupied by the module's internal OSPI PSRAM, so you can not use them as I2C port https://forum.elecrow.com/uploads/155/WW52G3I99CHF.png You can use the IO17, IO18 as I2C interface https://forum.elecrow.com/uploa…
-
Hello @letscode , The AI files and pdf are required. Please contact info@elecrow.com for details.
-
Hello @hymd , I'm sorry that I couldn't reply to you in time because I didn't receive the notification of your reply. Since we haven't used the Excel sheet for Elecrow PCBA for a long time, could you please send me this sheet? We will confirm wheth…
-
Hello @BitBuilder27 , Yes, this update also applies to the PlatformIO example.
-
Hello @cooljack , You can connect a voltage measurement circuit or module to GPIO_D port. https://www.elecrow.com/crowtail-voltage-sensor.html The pin number of GPIO_D port is IO25, you can use it as an ADC port. https://forum.elecrow.com/uploads/2…