DougWaterford
DougWaterford
About
- Username
- DougWaterford
- Joined
- Visits
- 23
- Last Active
- Roles
- Unconfirmed, Member
Comments
-
After a sometime and in desperation I tried a higher upload baud rate and it worked I had been using 921600 and 115200 but then tried 230400 with success.
-
I have tested the USB-Arduino connection with ESP32 DEV1 board no problems. I have a second unit but am reluctant to use it in case i have the same these were both purchased from ELCROW the last month.
-
Further attempts to upload result in this arduino message note the tool settings are correct. Chip is ESP32-S3 File "/home/douglas/.arduino15/packages/esp32/tools/esptool_py/3.3.0/esptool.py", line 5347, in <module> Features: WiFi…
-
The Arduino settings are the same as your example except I am using the USB connection. I am trying to run the example in the ELCROW tutorial "A7.0 Touch.ino" see in bold. Note neither the A7.Touch.ino or the "touch.h" included l…