Comments

• Currently, the program uses two "On Start" modules, but only one is correct.

  in Code upload fail, try again please. Comment by 530631831 September 2021
• Linux version of Letscode is under development, will be the first time after the completion of the shelf, thank you for your attention.

  in Letscode linux version Comment by 530631831 August 2021
• The steps to install Letscode & how to use it. https://www.elecrow.com/wiki/index.php?title=Mbits#Use_on_Letscode

  in Download link of the latest version of Letscode (Continually updated) Comment by 530631831 July 2021
• This is the latest version of Letscode software, welcome to download.

  in Download link of the latest version of Letscode (Continually updated) Comment by 530631831 July 2021
• This link has stopped updating.Please visit the latest link to download the latest software resources. https://forum.elecrow.com/discussion/150/download-link-of-the-latest-version-of-letscode-continually-updated#latest

  in Download link of the latest version of Letscode (This link stops updating) Comment by 530631831 July 2021
• Thank you for your valuable advice.A future software update will consider adding such a feature.

  in Crowbits letscode online extension Comment by 530631831 July 2021
• Thank you for your use, you can download the latest letscode software.After installation, use administrator privileges to open the software, and then use,can solve this problem.

  in Cannot upload code because firmware update failed Comment by 530631831 July 2021