Crowpnale flash via UART

Dhrulian · March 12

I am currently working on a project that requires flashing esp32 via UART line. I am using CrowPanel 5.0" HMI ESP32 Display 800x480. How can i read the boot logs of the ESP ? . I tried reading through the USB port at 115200 but i am getting garbage messages like ��L9�9

Jennie · March 12

HI Dhrulian，
Are you using the Arduino IDE? You can find relevant information on the wiki website (see below) according to your product SKU number.
https://www.elecrow.com/wiki/
Warm regards

Crowpnale flash via UART

Comments